ATA8742-PXQW【PDF 76/238 页】MCU W/TRANSMITTER ASK/FSK 24QFN

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录52

72页 73页 74页 75页 [76页]77页 78页 79页 80页

9151AINDCO07/09

ATA8742

are read back again, but as previously discussed, a nop instruction is included to be able to read

back the value recently assigned to some of the pins.

Note:

1. For the assembly program, two temporary registers are used to minimize the time from

pull-ups are set on pins 0, 1 and 4, until the direction bits are correctly set, defining bit 2 and 3

as low and redefining bits 0 and 1 as strong high drivers.

19.2.5

Digital Input Enable and Sleep Modes

As shown in Figure 19-2 on page 73, the digital input signal can be clamped to ground at the

input of the schmitt-trigger. The signal denoted SLEEP in the figure, is set by the MCU Sleep

Controller in Power-down mode, Power-save mode, and Standby mode to avoid high power

consumption if some input signals are left floating, or have an analog signal level close to V

/2.

SLEEP is overridden for port pins enabled as external interrupt pins. If the external interrupt

request is not enabled, SLEEP is active also for these pins. SLEEP is also overridden by various

other alternate functions as described in Alternate Port Functions on page 77.

If a logic high level (one) is present on an asynchronous external interrupt pin configured as

Interrupt on Rising Edge, Falling Edge, or Any Logic Change on Pin while the external interrupt

is not enabled, the corresponding External Interrupt Flag will be set when resuming from the

above mentioned Sleep mode, as the clamping in these sleep mode produces the requested

logic change.

Assembly Code Example

(1)

...

; Define pull-ups and set outputs high

; Define directions for port pins

ldi r16,(1<<PA4)|(1<<PA1)|(1<<PA0)

ldi r17,(1<<DDA3)|(1<<DDA2)|(1<<DDA1)|(1<<DDA0)

out PORTA,r16

out DDRA,r17

; Insert nop for synchronization

nop

; Read port pins

r16,PINA

...

C Code Example

unsigned char i;

...

/* Define pull-ups and set outputs high */

/* Define directions for port pins */

PORTA = (1<

DDRA = (1<

/* Insert nop for synchronization*/

_NOP();

/* Read port pins */

i = PINA;

...

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式